Scale Setting; Mitre Fence Adjustment; Blade Tilt Stop Setting; Saw Cleaning - Metabo PK 200 Instructions D'utilisation Originales

34
4. Hold saw spindle with 13 mm open
jaw wrench and loosen arbor bolt
(36) with Allen key (L.H. thread!).
36
5. Take blade off the saw spindle.
6. Clean clamping surfaces of saw
spindle and saw blade.
A
Danger!
Do not use cleaning agents
(e.g. for removing resin residue) that
could corrode the light metal compo-
nents of the saw; the stability of the
saw would be adversely affected.
7. Put on a fresh saw blade (observe
direction of rotation!).
A
Danger!
Use only suitable saw blades
according to EN 847-1 (see "Techni-
cal Specifications" – when using
unsuitable or damaged blades parts
could be explosive-like hurled from it
by centrifugal force.
Do not use:
− saw blades which permissible
maximum speed is below the
rated no-load speed of the saw
spindle (see "Technical Specifica-
tions");
− saw blades made of high speed
steel (HSS);
− saw blades with visible damage;
− cut-off wheel blades.
A
Danger!
− Mount saw blade only using gen-
uine parts.
− Do not use loose-fitting reducing
35
rings; the saw blade could work
loose.
− Saw blades have to be mounted
in such way that they do not wob-
ble or run out of balance, and can
not work loose during operation.
8. Slide outer blade collar onto blade
spindle (observe centring of blade
collar).
9. Screw in arbor bolt (L.H. thread!)
and tighten fingertight with the
Allen wrench supplied.
A
Danger!
− Do not extend arbor bolt tighten-
ing wrench.
− Do not tighten arbor bolt by hit-
ting the Allen key.
10. Fasten cover plate to chip case.
11. Fasten removable table section.
12. Attach blade guard.
9.2

Scale setting

The scale can be set to correspond with
the saw blade thickness:
1. Loosen fixing screws and adjust
scale as required (37).
2. Tighten fixing screws and verify set-
ting by making a trial cut.
9.3

Mitre fence adjustment

1. Use try square to check if mitre
fence is at ringht angle to the saw
blade.
2. Loosen fixing screws (38) and
adjust graduated arc scale, if neces-
sary.
3. Tighten fixing screws.
9.4
1.
2.
3.
4.
37
5.
6.
9.5
1.
2.
9.6
A
− it can not be started by unauthor-
− nobody can get hurt.
38
outdoors or in damp environment.
3
blocked by a padlock.
ENGLISH

Blade tilt stop setting

Set the blade tilt limiter (39) to the
left ( 0° to 45° position).
39
Check blade bevel angle:
− 0° = square with the saw table
− 45° with separate mitre square.
If these angles are not exactly
matched:
Remove removable table section.
Adjust setting screws (40) of stops
until the blade tilt against the saw
table at the end positions is exactly
0° (= square) and 45°, respectively.
40
After adjusting the stops the angle
scale at the machine front may need
readjustment.
Fasten removable table section.

Saw cleaning

Lay machine on its side.
Remove chips and saw dust with
vacuum cleaner or brush:
− from saw blade setting guide ele-
ments;
− from motor vent slots.

Machine storage

Danger!
Store saw so that
ized persons and
A
Caution!
Do not store saw unprotected
Note:
The ON/OFF buttons can be
19