AneX m/type Manuel D'entretien page 9

a foot cover which can be fixated on the inner
lateral sides of the strolling block's seat and on the
middle of the barrier by using buttons (Fig. 32).
Footrest adjustment
To lower the footrest, simultaneously press the
buttons on both sides of the footrest and adjust
to the required height (Fig. 33). The footrest can
be lifted without pushing any buttons.
Seat unit's security barrier
The seat unit is equipped with a barrier, which
prevents your child from falling off the stroller. To
install the barrier, insert it into the holder bores on
both sides of the seat unit (Fig. 34). To dismantle
the barrier, press the buttons and slightly draw
the handle up (Fig. 35). You can also dismantle one
side of the barrier and leave the other.
Safety belts
The seat unit features 5-point safety belts.
To secure a child with protective belts, insert
the safety belt locks into the grabber and
tighten those belts (Fig. 36). You can also
adjust the length of the safety belts, if you want
to make them shorter — pull the end of the
strap, to extend safety belts — turn the plastic
adjuster up and pull the lower strap. To change
the position of the upper seat belts check the
plastic holder that is on the outside of the back
inside the sewing, pull out the belt together
with the plastic holder, insert the belt with the
plastic holder in the required position, and
then make sure the plastic holder is in correct
position (Fig. 45). To remove/assemble safety
belts repeat the previous moves. If you need to
unfasten them, press the buttons and remove
the clips from the buckle (Fig. 36).
Child safety seat
The child safety seat can be mounted on this
stroller's frame as well. It must be attached
to tailor-made adapters (Fig. 37). To secure
the removable child safety seat, insert the
adapters into the adapter pockets on the
frame, then secure it (Fig. 38). The adapters
are blocked automatically. To remove the
adaptor from the frame, press the memory
buttons of the adaptors (Fig. 39). To take the
safety seat off the adaptors, simultaneously
push the buttons under the textile on both
sides of the seat (Fig. 40). It is also possible to
adjust the transportation handle by simulta-
neously pressing the red buttons on both
sides of the seat and adjusting to the required
position. The safety seat can be installed both
with the standard car safety belts and with the
help of ISOFIX fixation system.
Please carefully read the the manual instruction
before using the safety seat.
Installing additional
accessories on the frame
There are special holders situated on both sides
of the frame for TM Anex branded cupholder.
The stroller is also equipped with a shopping
basket, which is attached to the bottom part
of the frame with zippers (Fig. 41). A backpack
for parents is also provided.
Maintenance and cleaning
Please ensure that the stroller is kept clean
and dry (both the coating and the frame).
In case the stroller gets dirty or wet, it should
be dried, and the metallic parts be cleaned with
a dry cloth. Avoid getting dirt (sand, dust, etc.)
on the stroller. Clean the dirt off the stroller
EN
9