Storage; Replacement Parts - for_q FQ-AKS 4030 Mode D'emploi

- Turn the saw chain by hand to
check that it runs perfectly. It must
slide freely in the guide bar.
- Tighten the handwheel to attach
the guide bar and the chain sprock-
et cover 3
Note: Check and re-adjust the tensi-
on of a new chain after working for
a few minutes. Switch the motor off,
remove the battery and actuate the
chain brake.
Cleaning oil guide groove in the
guide bar
- Remove guide bar.
- Remove dirt from the oil guide
groove using a suitable tool. Use a
plastic spatula, not a steel tool!
- Re-attach guide bar.
Regrinding saw chain
Special tools are required to sharpen
the saw chain and guarantee that the
blades of the chain are sharpened at
the correct angle and to the correct
depth. We recommend having the
saw chain reground by specialist.

Storage

- Store the unit in a dry and frost-free
place (10-25 °C).
- Store the battery and the unit sepa-
rately.
- Charge the battery before storing
the unit in winter.
- For a prolonged period of non-use
always drain the chain lubricating
oil out the power tool.
- Place sheath on cutting mecha-
nism.
- Keep the unit, in particular its plas-
tic components, away from brake
fluids, petrol, petroleum products,
penetrating oil, etc. They contain
chemical substances which may
damage, attack or destroy the plas-
tic components of the unit.
- Fertilisers and other garden chemi-
cals contain substances which may
have a highly corrosive effect on
the metal parts of the unit. There-
fore do not store your unit near
these substances.

Replacement Parts

Please quote the following data when
ordering replacement parts:
- Type of machine
- Article number of the machine
- Identification number of the ma-
chine
- Replacement part number of the
part required
Guide bar
310 mm 6126171
(12")
On request in the market.
Saw chain
6126172
EN
177