Lubricating the chain
Caution! The unit may be op-
erated with adequate chain
lubricating oil only. Inadequate lu-
brication will reduce the service
life of the power tool.
1. Check the chain oil level at the oil
level indicator 11 and top up with
chain oil if required.
2. Fill the unit only with an envi-
ronmentally compatible quality
chain and bar lubricant (accord-
ing to RAL-UZ48).
3. Do not use waste oil. Renewed
contact with waste oil can cause
skin cancer. Waste oil is environ-
mentally harmful. Waste oil does
not have the necessary lubricat-
ing properties and is unsuitable
for chain lubrication.
4. Any oil other than the one recom-
mended may damage the guide
bar, the chain and the lubricating
system.
5. Ensure that dirt does not get into
the oil tank.
6. Avoid spilling oil. Always wipe up
any spilled oil.
Checking the chain lubrication
1. Start the unit (see "Switching on/
off").
2. Hold running saw chain for some
time approx. 15 cm above a suit-
able surface. If there is adequate
chain lubrication, the oil which is
ejectedby the saw chain will form
a light trail.
EN
172
Battery
STATE OF CHARGE
Press the button to check the state of
charge on LED indicator. To charge
consult the user manual of the charg-
er.
≤ 25 %
≤ 50 %
≤ 75 %
≤ 100 %
Using the device
Warning! Before using the
power tool, familiarise your-
self thoroughly with the sawing
technique of chain saws (see sec-
tion "Basic working technique").
Risk of injury! Never allow children
to operate the chain saw. Allow no
person to use this chain saw who
has not read this user manual or
received adequate instructions for
the safe and proper use of this
chain saw!
Warning! Hold the chain saw
firmly with both hands! En-
sure that the saw chain does
not touch any objects or the ground
and that there are no people or
animals in the vicinity before start-
ing! Risk of injury!