Attaching Guide Bar And Chain; Fill In Chain Oil; Chain Brake - for_q FQ-AKS 4030 Mode D'emploi

Attaching guide bar and chain

1
Unscrew the handwheel 5 and re-
move the chain sprocket cover 3.
Warning! The saw chain 7 is
very sharp! Wear protective
gloves. Risk of injury!
(1.) Put the saw chain 7 into the
3
guide bar 6 in the right running
direction. (2.) Fit the guide bar
6 into the chain saw. Place the
chain 7 around the sprocket. (3.)
Straighten the chain 7 with the
chain tensioning wheel 4.

Fill in chain oil

1
Unscrew the oil tank cover 18
and carefully fill the oil tank 12
to the MAX mark. Screw the
cover 18 back on.

Chain brake

1
Pull the hand guard 8 towards
the handlebar 1 to deactivate
the chain brake.
Warning! Make sure that the
chain brake works properly.
2
Turn the chain tensioning wheel
4 to move the guide bolt a.
Caution! When attaching the
chain 7, observe the running
direction!
Ensure that the saw chain 7
4
slides freely in the guide bar 6
and can be pulled 2-4 mm off
at its middle. Attach the chain
sprocket cover 3 and tighten
the handwheel 5.
Insert Battery
2
Press the charged battery into
the insertion slot 17 until it
clicks into place.
To remove, press the release
button (1.) and pull out the bat-
tery (2.).
Switching on/off
2
Deactivate the chain brake,
press and hold the release but-
ton 16. Press the On/Off switch
15 and release the release but-
ton 16. Release to switch off.
EN
171