Metal Works CAT410 Mode D'emploi page 7

CAT410 - NLFRENES - v2.0 - 15082013
EN
3.3 Shelf installation
1. Stand cabinet upright.
2. Remove eight M6x12 bolts, 16 washers and eight nuts from bolts package.
3. Insert eight M6x12 bolts and washers through holes in leg and shelf, place
washers and spring washers and nuts over bolts and tighten.
4. Tight leg bolts and level cabinet.
3.4 Cabinet leg trim moulding
Enclosed are four trim mouldings for bottom of cabinet legs. They may be
pushed in place, without tools.
3.5 Air requirements
For best results, we recommend a good 5 hp air compressor.
4 Operating instructions
• Your workshop air hose enters front opening of cabinet and is connected to the air inlet of Power Gun.
Bottom handle of gun has 1/4" pipe threads which will fit most air hose. Cabinet pickup tube leads to
clear syphon hose which connects to gun head assembly.
• Pour glass beads or other abrasive into cabinet hopper through the side loading door. Place parts to be
blasted in cabinet and close door.
• With hands in cabinet gloves aim power gun at object. Pull trigger and let our unique siphon recycling
system do the rest. Rust, paint and scale are quickly removed leaving the original metal clean and intact.
Abrasive drops to the bottom of cabinet for continual recycling each time power gun is activated.
• Abrasive can be re-used until it eventually breaks down or becomes dusty. To discard worn abrasive simply
place empty box under spring loaded trap door. Add more abrasive and resume blasting.
• Your shop vac connects to vacuum ferrule is necessary to remove the dust created in blasting. When using
a shop vacuum, be sure to install the paper filter over the standard filter. Otherwise, abrasive could work
its way into the vacuum motor, causing bearing failure.
• At right front of cabinet is an opening for your air hose from your compressor. An ordinary 3/8" ID air
house should fit through this opening.
• Connect your air hose to bottom handle of power gun by screwing into place. (use teflon tape or pipe
compound (do not over tighten). Close door and pull trigger a few times to test operation. You are now
ready to add abrasive.
• Add suitable abrasive by pouring through side door opening and allowing it to fill funnel area. Do not
over fill (1/2 full below work area screen is best).
Note: use a fine grade of abrasive to prevent clogging. We recommend straining, through a double layer of
ordinary window screen. If it passes through the screen it will pass through the nozzle.
You are ready to start blasting.
®
7