Safety Instructions - Metal Works CAT410 Mode D'emploi

1 Safety instructions

• Keep the work area clean. Clean cluttered areas invites injuries.
• Keep children away. All children should be kept away from the work area. Don't let them handle the tool.
• Wear goggles or safety glasses during operation. Glass lens is 5 mm tempered, but still breakable.
Replace only with tempered or safety glass. Size: 610 mm x 3.4 mm.
• Use grounded receptacle only for electrical connection. Require 230 volts to operate vacuum.
• Wear cabinet gloves. Replace as necessary.
• Close and latch door during operation.
• Disconnect incoming air line when adding abrasive, or when servicing hoses, power gun, or other
components.
• Maximum operating pressure - 125 Psi/8.61 bar.
2 Specifications
Characteristic
Dimensions (mm)
Weight (kg)
Electrical requirement of light (V)
Maximum operation pressure
2.1 Spare parts: see page 10
3 Assembling
3.1 Legs installation
1. Place cabinet on its back on a table or bench.
2. Insert M6x12 bolt through leg and into cabinet.
3. Place M6 washer and M6 lock washer over bolt and M6 hex nut. Hand
tighten.
4. Repeat above for remaining three legs.
3.2 Funnel, net and frame
1. Stand cabinet upright.
2. Place net on funnel.
3. Remove four M6x25 bolts and washers and four hex nuts from bolt package.
4. Insert four M6x25 bolts and washers through holes in funnel frame
foundation into cabinet. Place washers and nuts over bolts and tighten.
6
®
Value
860 X 1390 X 560
48
230
125 PSI / 8.61 bar
CAT410 - NLFRENES - v2.0 - 15082013
EN