Complete Installation - Whirlpool KEBU208SSS00 Instructions D'installation

2. Push against seal area of front frame to push oven into
cabinet.
3. Push oven completely into cabinet and center oven into
cabinet cutout.
4. Securely fasten oven to cabinet using the #8-14 x 1" screws
(2 for single oven, 4 for double oven) provided. Insert the
screws through holes in mounting rails. Do not overtighten
screws.
A
B
A. Mounting rail
B. Insert #8-14 x 1" screw.
5. On some models, the oven vent is taped to the side of the
oven.
With one #8-14 x ³⁄₈" screw for each side of the vent, fasten
vent securely to the oven.
A
A. #8-14 x
B. Oven vent
6. Replace oven racks.
7. Replace oven door(s) by inserting ends of hinges into hinge
slots in the oven frame.
8. Push hinges in as far as they will go and open the oven door.
You should feel the oven door drop into place.
B
³⁄₈
" screw
9. Rotate both hinge latches back to the locked position.
10. Check that the door is free to open and close. If it is not,
repeat the removal and installation procedures. See "Remove
Oven Door" section.
11. Reconnect power.
12. Display panel will light briefly, and "PF" should appear in the
display.
13. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Single Oven
1. Turn power on.
2. From the Main Menu touch STEAM COOK.
3. Touch AUTO STEAM.
4. Touch VEGETABLES.
5. Touch START, then OK.
If oven(s) does not operate, check the following:
Household fuse is intact and tight; or circuit breaker has
not tripped.
Electrical supply is connected.
See "Troubleshooting" section in the Use and Care Guide.
6. When oven has been on for 10-15 minutes, open the oven
door, look for water vapor escape and feel for heat.
If you do not see water vapor or feel heat or if an error code
("F" followed by a number plus "E" followed by a number)
appears in the display, turn off the oven and contact a
qualified technician.
7. Touch OFF.
Check Operation of Double Oven
1. Turn power on.
2. Touch UPPER OVEN or LOWER OVEN, to select the oven
you are testing.
3. Repeat "Check Operation of Single Oven" steps 1-7.
To set the clock and other oven functions, refer to the Use and
Care Guide.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in oven.
9