Mitsubishi Electric MSZ-WN25VA Notice D'utilisation page 6

● OPERATING INSTRUCTIONS ●
F
AN SPEED AND AIRFLOW DIRECTION ADJUSTMENT
Press to select fan speed. Each press changes
fan speed in the following order:
(AUTO) (Low)
• Two short beeps are heard from the indoor unit when set to AUTO.
• Use higher fan speed to cool/heat the room quicker. It is recommend-
ed to lower the fan speed once the room is cool/warm.
• Use lower fan speed for quiet operation.
Press to select airfl ow direction. Each press
changes airfl ow direction in the following order:
(AUTO) (1) (2)
• Two short beeps are heard from the indoor unit when set to AUTO.
• Always use the remote controller when changing the direction of air-
flow. Moving the horizontal vanes with your hands causes them to mal-
function.
E
CONO COOL OPERATION
Press during COOL mode
ECONO COOL operation.
The unit performs swing operation vertically in various cycles according
to the temperature airflow.
Press again to cancel ECONO COOL operation.
• ECONO COOL operation is also cancelled when the VANE button is
pressed.
What is "ECONO COOL"?
Swing airfl ow (change of air fl ow) makes you feel cooler than stationary airfl ow.
The set temperature and the airfl ow direction are automatically changed by the
microprocessor. It is possible to perform cooling operation with keeping comfort.
As a result energy can be saved.
En-5
(Med.) (High) (Super High)
(3) (4) (5) (SWING)
page 4 to start
Airflow direction
(AUTO) .........The vane is set to the most effi cient airfl ow direction. COOL/
DRY/FAN:horizontal position. HEAT:position (5).
(Manual) .......For efficient air conditioning, select the upper position for
COOL/DRY, and the lower position for HEAT. If the lower
position is selected during COOL/DRY, the vane automatically
moves to the upward position after 0.5 to 1 hour to prevent
any condensation from dripping.
(Swing) .........The vane moves up and down intermittently.
I To change the horizontal airfl ow direction.
Move the vertical vane manually before starting operation.
T
IMER OPERATION (ON/OFF TIMER)
1
Press or during operation to set the timer.
(ON timer) : The unit turns ON at the set time.
(OFF timer) : The unit turns OFF at the set time.
* or blinks.
* Make sure that the current time and day are set correctly.
2
Press (Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while or
3
Press or again to cancel timer.
Note:
• ON and OFF timers can be set together.
operations.
• If power failure occurs while ON/OFF timer is set, see
function".
Page 4
(Decrease) to set the
is blinking.
mark indicates the order of timer
page 4 "Auto restart