M-system MI-21 Mode D'emploi page 61

Trouble shooting
When the symbol [ E 4 ] appears :
The table must be reconfigured. Please implement the following steps:
I)
Make sure there is no more pot on the hob.
II) Disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off.
III) Reconnect the table to the grid.
IV) Procedure:
* take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don't use the [ O/I ] touch
V) First step : cancel the existing configuration
1) Press [ - ] and hold down
2) With your other hand, press successively and quickly (less than 2s) on each [ O ] key.
Begin from the front right side and turn contrary clockwise, as described on the picture
(from a to d).A double "beep" means an error occurred. If so, start again from item 1).
3) Remove your fingers from the touch control, press simultaneously [ + ] and [ - ] during
few seconds, until blinking [ E ] symbols appear.
4) Wait until [ E ] symbols stop blinking.
5) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup has
been cancelled.
VI) Second step: new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ O ] key
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off. Please use the
same pot for the whole procedure. Never put several pots together on the zones during
the setup-process. If [ E 4 ] displaying remains, please call the customer care
NL
FR
D
EN
61