Cembre B35-B45MD Notice D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH
2.4) Release of dies
Press the pressure release button (9), the ram will retract and open the dies.
2.5) Head rotation
For ease of operation the tool head can rotate through 180°, allowing the operator to work in the
most comfortable position.
Warning: do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.6) Replacement of dies
To replace the dies, open the head and extract them from their seats.
2.7) Battery status
The battery is equipped with LED indicators that indicate the remaining battery life at any time by
pressing the adjacent button (P).
4 LEDs illuminated: Fully charged
2 LEDs illuminated: 50 % capacity
1 LED fl ashing: Minimum charge, replace the battery
W
W
HEN THE BATTERY VOLTAGE HAS DROPPED BELOW A MINI
HEN THE BATTERY VOLTAGE HAS DROPPED BELOW A MINI
MUM SAFETY THRESHOLD
MUM SAFETY THRESHOLD
IT IS NECESSARY TO RECHARGE OR REPLACE THE BATTERY
IT IS NECESSARY TO RECHARGE OR REPLACE THE BATTERY
The approximate time to fully recharge a battery is about 40 minutes.
2.8) Insertion/replacement of battery
To replace the battery, remove it by pressing the release button (15) (Ref. to Fig.5 page 24), then
insert the new battery, sliding it into the guides until it locks.
3. WARNING
Before starting work on electrical equipment, please ensure that either there are no live parts in
the immediate working area or that precautions are taken for working near live parts in accordance
with EN50110-1.
D
O NOT USE THIS TOOL ON OR NEAR ENERGIZED CONDUCTORS WITHOUT PROPER PERSONAL PROTEC
TIVE EQUIPMENT
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO COOL DOWN FOL
LOWING UNINTERRUPTED
A FULLY CHARGED BATTERY IN ONE SESSION
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER SUPPLY
(Ref. to Fig. 3)
,
,
THE TOOL WILL NOT START
THE TOOL WILL NOT START
.
FAILURE TO OBSERVE THIS WARNING COULD RESULT IN SEVERE INJURY OR DEATH
,
SUCCESSIVE CRIMPING OPERATIONS
-
-
,
,
AND
AND
.
.
;
FOR INSTANCE
,
DELAY BATTERY REPLACEMENT FOR A FEW MINUTES
2
P
FIG. 3
-
.
-
,
HAVING EXHAUSTED
.
.
6

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

B35-45mdaB35-45mdeB35-45mdtB35-45md

Table des Matières