Cembre B35-B45MD Notice D'utilisation page 5

2. INSTRUCTIONS FOR USE
2.1) Preparation (Ref. to Figs. 1, 2)
With the tool in the rest position, proceed as follows:
– Select the appropriate die set for the connector.
– Open the latch (25) and release the upper die holder (24).
– Insert one die into the upper die holder (24) and one die into the lower die support (33).
For indent crimping, the nest MA... must be inserted in to the upper die holder (24), and the
indentor PA... must be inserted into the lower die support (33).
– Close the latch (25).
– Insert the conductor in the
connector.
– Position the connector be-
tween the dies and ensure the
correct location of the crimp.
Ensure that the latch and the
upper die holder are fully
secured, otherwise damage
may occur during tool ope-
ration.
2.2) Die advancement
– Grip the tool fi rmly and comfortably and press the operating button (4) to activate the motor-
pump and advance the lower die. To halt the advancement, release the operating button (4) and
the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise re-open dies
following instructions as per § 2.4 and reposition the connector.
2.3) Compression
– By keeping operating button (4) pressed, the motor continues to operate: the ram will gradually
move forward until the two dies touch.
It is recommended to keep operating until the maximum pressure valve is activated and a "click"
is heard.
– The motor will continue to operate after the maximum pressure relief valve has activated.
No further crimping force is applied, the oil is bypassed and returned to the reservoir.
5
24
MA ...
25
PA ...
33
ENGLISH
FIG. 2