Nosepiece Replacement; Belt Hook Adjustment - Senco DS522-18V Mode D'emploi

1. Without removing feed system
i. Remove fasteners from the tool.
ii. Slide bit release button to rear.
iii. Tilt tool forward and pulse trigger.
EN
iv. Bit will fall out.
v. Hold tool upright.
vi. Insert the new bit into the slide body.
vii. Slide bit release button to rear.
viii. Pulse tool and release button when bit drops into place.
2. Removal of tool front end/feed system
i. Turn the locking collar on the detachable feed system to the unlock position.
ii. Slide the feed system off the tool to expose the bit.
iii. Slide bit release button to rear.
iv. Pull the old bit out and release button.
v. Insert the new bit into the bit retainer and push until it clicks into place. (Slight rotation of the bit may be
necessary for proper alignment and full insertion.)
vi. Install feed system and rotate collar to lock position.

NOSEPIECE REPLACEMENT

1. Remove battery before changing the nosepiece.
2. Remove retention screw with flat-tip screwdriver.
3. Set the nosepiece on the longest setting possible.
4. Depress the screw selector pin until it is completely depressed. It will be necessary to use a screw or thin object
to depress to this depth.
5. While holding the pin in this position, slide the nosepiece forward and off the slide body
6. Install the new nosepiece.
7. Replace the nosepiece retention screw ensuring it is seated snug against the slide body.

BELT HOOK ADJUSTMENT

To adjust the belt hook offset from the tool:
1. Remove the belt hook thumb screw until the locking plate can be removed.
2. Slide the belt hook out to the desired position, replace the locking plate, then re-install the thumb screw.
To relocate the belt hook to opposite side of the tool:
1. Remove the thumb screw, locking plate, threaded plate and belt hook.
TOOL OPERATION
14