Meec tools 015385 Mode D'emploi page 27

test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 62841-2-2:2014.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
The product is a part of the Meec Tools
Multiseries 18 V – a series of power tools
and garden equipment that uses the same
battery and charger. Battery, charger and other
accessories can be bought in Jula's department
store and at www.jula.com.
1. Anvil/tool holder1/4"
2. LED light
3. Power switch
4. Rotation selector
5. Ventilation openings
6. Grip
7. Clip for pants/belt
8. Battery compartment
9. Battery
10. Release lock
11. Battery charger
FIG. 1
USE
BATTERY
Powerful battery for machines and tools in the
Meec Tools Multiseries. On the short side of the
battery there is a battery power indicator, which
shows the residual battery power in four steps.
Click the indicator button to see the battery level.
NOTE:
• Do not dismantle the battery or attempt
to replace the battery cells.
• Short circuiting the battery terminals on
this battery by jewellery or tools can
result in serious burn injuries.
• Store the battery in a dry place at no
more than 27 °C.
• Store the battery with a 30% – 50%
charge.
• Charge the battery every seven months
during long-term storage.
CHARGING THE BATTERY
Make sure to do the charging in a suitable
place and to use the right charger. Only
batteries and chargers in the Meec Multi
Series must be used with this product. Never
connect an unknown charger, or a charger,
charging cord or battery that can be suspected
to be defective. Otherwise there is a risk of
overheating, and in the worst case fire.
FITTING THE SOCKET
IMPORTANT:
Make sure the product is switched off
(rotation selector in middle position and
trigger released) before fitting or removing
the socket. Check that the socket size (width
of jaw) matches the size of screws or nuts
to be tightened. The wrong size of socket
damages the nuts/screw heads.
EN
27