Publicité
Les langues disponibles
Les langues disponibles
Model
Weight(kg)*
galvanised steel rope
4.9 mm
PE rope – HD
5.5 mm
webbing PES width 46 mm
webbing PES width 25 mm
webbing Aramid + PES width 16 mm
Retraction force (N)
Braking distance (mm)
Horizontal use
L Min (m)
M Max (m)
Device securing
Attaching the retractable lanyard
* Devices fitted with M10 and M47 connectors except model B1.8B ESD fitted
with M47 and M51 connectors.
1. General warning
1. Before using your blocfor™ self-retracting fall-
arrester device, and to ensure safe, efficient use of
the harness, it is essential that the user be properly
trained in the use of the equipment and has read
and understood the information given in the manual
supplied by TRACTEL SAS. This manual should be
available at all times to all users. Additional copies
can be supplied on request.
2. Before use, it is essential that users are trained in
the use of this safety device. Check the state of
associated equipment and make sure that there is
adequate room for movement.
3. The blocfor™ self-retracting fall-arrester must only
be used by a single trained and skilled operator, or
by an operator under supervision of a user.
4. Any blocfor™ self-retracting fall-arrester device
which does not appear to be in good condition or
which has already served to stop a fall should be
inspected, with all its associated equipment, by
TRACTEL SAS or by a qualified technician who must
give written authorisation for re-use of the system.
It is recommended to make a visual inspection prior
to each use.
5. Any modification or attachment made to the
equipment cannot be done without prior written
approval from TRACTEL SAS. The equipment must
be transported and stored in its original packaging.
6. Any blocfor™ self-retracting fall-arrester which has
not been inspected over the past 12 months (or in
accordance with the statutory inspection requirement
of the country of use) or which has served to stop a
Technical specifications
B1.8A
B1.8B
B2
ESD
ESD
ESD
0.98
1.30
1.02
–
–
–
–
–
–
–
–
2
–
–
–
1.8
1.8
–
3 to 15
3 to 15
3 to 15 5 to 25 5 to 25 5 to 25
500
500
400
OK
OK
–
1
1
–
0.5
0.5
–
Anchorage
Operator
point
Anchorage
Operator
point
7. The maximum working load for the blocfor™ self-
8. If the mass of the operator increased by the weight
9. This device is suitable for use on an open air site
10. If you are responsible for assigning the equipment
11. The operator must be physically and mentally fit
12. The equipment should not be used beyond its limits
13. The blocfor™ self-retracting fall-arrester systems
B5
B6
B10
B10 SR
ESD
ESD
ESD
ESD
2.17
2.22
4.90
4.07
–
–
10
–
–
–
–
10
–
–
–
–
5
6
–
–
–
–
–
–
5 to 25
800
800
800
800
OK
OK
OK
OK
3
3
3
3
1.5
1.5
1.5
1.5
Anchorage point
Operator
fall must not be used. They can only be used again
after a new periodical inspection carried out by an
approved and competent technician who can offer
written permission for use. Failing these reviews and
approvals, the blocfor™ self-retracting fall-arrester
will be disassembled and destroyed.
retracting fall-arrester is 150 kg.
of their equipment and tools is between 100 kg
and 150 kg, you must ensure that the total weight
(operator, equipment + tools) does not exceed the
maximum load of each of the components of the fall-
arrest system.
and for a temperature range of -35°C to +60°C. Avoid
any contact with sharp edges, rough surfaces and
chemical substances.
to an employee or similar person, ensure that you
comply with the applicable health and safety at work
regulations.
when using this equipment. In case of doubt, check
with one's private doctor or with the works doctor. It
is forbidden for use by pregnant women.
or in any other situation other than what it has been
designed for (cf. "4. Functions and Description").
should be personally assigned to each operator, in
particular where salaried personnel are concerned.
B20
B20 SR
B30
B30 SR
ESD
ESD
ESD
ESD
8.50
7.05
15.70
13.50
19
–
30
–
–
18.2
–
30
–
–
–
–
–
–
–
–
–
–
–
–
5 to 25
5 to 25
5 to 25
5 to 25
800
800
800
800
OK
OK
OK
OK
3
3
3
3
1.5
1.5
1.5
1.5
3
GB
Publicité
