Güde GMS 45 Mode D'emploi page 8

Introduction
To enjoy your new appliance as long as possible,
please read carefully the Operating Instructions and
the attached safety instructions before using it. We
recommend keeping the Operating Instructions for
future reference. As part of our continuous
improvement of our appliances, we reserve the right
to make technical changes to improve the
appliance.
Supply includes
1. GMS 45 knife sharpener
2. Instructions for Use
3. International service centres
Appliance (pic. 1) description
Housing body
1.
2. On/Off
3. Knife slot "1" coarse sharpening
4. Knife slot "2" fine sharpening
5. Power cable
6. Rubber legs
7. Stoppers of inlet to the dust collector
8. Housing screws
GMS 45 knife sharpener technical specifications
Connection:
Engine power:
Speed:
Sharpening disc diameter:
Protection class
Noise level:
Weight:
General safety instructions
When using a power tool, basic safety measures
must be observed to prevent a risk of fire,
electric shock and injury of persons, including
the following:
Please read and follow all these instructions before
putting the appliance into operation.
Keep the safety instructions for future reference!
The appliance has not been designed to be used by
persons (including children) with reduced physical,
sensory or mental abilities or with a lack of
experience / knowledge, unless being supervised by
a person responsible for their safety or having
received instructions on how to use the appliance
from such person.
Children should be supervised to make sure they do
not play with the appliance. Always tell children and
unauthorised person to stay away from the
appliance.
The appliance may only be operated with
an RCD (max. fault current 30mA).
230V~50 Hz
45 W / P1
-1
2,800 per min
47 mm
II
L 55 dB
WA
1.3 kg
8
Before putting the appliance into operation, a
qualified electrician must check that the required
electrical safety measures are taken.
In doing so, national regulations must be complied
with.
Electrical connection must be provided through a
socket.
Care must be taken to make sure the connecting
socket is away from water and moisture and the
plug is protected against moisture.
Check the voltage. The technical specifications on
the type plate must correspond with the mains
voltage.
Before putting the appliance into operation, check
the electric cable and/or socket for damage.
To avoid danger, a damaged power cable must be
replaced by the manufacturer. Do not repair the
cable yourselves under any circumstances.
If the appliance starts abnormally vibrating, turn off
the engine and locate the cause immediately.
Vibrations are usually a warning against a
malfunction.
Keep the place of your work clean and tidy!
A mess in the place of work can result in injuries.
Consider the environment
Do not expose the appliance to rain.
Do not use the appliance in moist or wet conditions.
Provide adequate lighting.
Do not use the appliance near flammable liquids or
gases.
Protect yourself against electric shock!
Avoid body contact with earthed parts.
Keep other persons in safe distance!
Do not let other persons, especially children, to
touch the appliance or cable. Do not let them
access the place of your work.
Store your tools and appliances!
Tools and appliances not being used must be kept
in a dry, locked place and out of reach of children.
Do not overload your appliance!
You will work better and safer within the specified
output range.
Use the right appliance!
Do not use appliances with weak performance for
hard work. Do not use the tool for purposes for
which it has not been designed.
Wear appropriate work clothing!
Do not wear loose clothing or jewels as they could
get caught by the rotating parts.
Non-slip shoes are recommended for outdoor
works. Wear a hairnet if you have long hair.
Use protective equipment!
Always wear safety glasses.
Use a breathing mask for works where dust is
produced.