Dräger X-dock 5300 Notice D'utilisation page 26

Maintenance
3. Select >
configuration > Update.
A list of all firmware updates
available on the USB storage
device will be displayed.
4. Select the desired
update from the list. The selected
firmware update is marked blue.
5. Start firmware update using OK.
The installation progress will be
displayed.
6. Following successful transfer to the station, the start is re-
started automatically and the firmware update is installed
immediately afterwards. During the installation process,
the status LEDs on the modules will be white.
7. After the installation is complete, the station changes to
operating mode. The station is ready for operation.
26
System
firmware
6.5 Changing the sealing insert
NOTICE
i i
The sealing inserts must be changed at regular
intervals (e. g. at each inspection) or sooner as
required.
1. Open the module cover.
2. Squeeze the two external
locking lugs in
withdraw the sealing insert
downwards.
3. Release the hoses from
the sealing insert.
4. Replace the sealing insert.
5. Fit the hoses to the new
sealing insert (note the
arrows on the sealing
insert and the hose).
6. Squeeze the external
locking lugs in and insert
the sealing insert into the
module cover until the
locking lugs engage.
7. Check that the sealing
insert is fitted correctly in
the module cover.
and
Dräger X-dock 5300/6300/6600
00633286.eps
00733286.eps