CAPTELEC S 7010 Mode D'emploi page 34

S 7010 /
CCS701-12
6) Sawing with parallel guide
The parallel guide enables exact cuts along a work piece edge and cutting strips of the same dimension.
- Slide the scale of the parallel guide through the guide in the base plate.
- Adjust the desired cutting width as the scale setting at the respective cutting mark
- Tighten bolts.
7) Inserting the battery
- Use only original lithium-ion batteries with the voltage listed on the nameplate of your power tool. Using other
batteries can lead to injuries and pose a fire hazard.
- Insert the charged battery from the front into the base of the power tool. Push the battery completely into the base
until the red stripe can no longer be seen and the batter is securely locked.
8) Switching On and Off
- To start the machine, first push the lock-off button ⑤ and then press the On/Off switch ② and keep it pressed.
- To switch off the machine, release the On/Off switch.
Note: For safety reasons, the On/Off switch ② cannot be locked; it must remain pressed during the entire operation.
9) Temperature Control/ Overload Protection Indicator
The red LED indicator will help you in protecting the battery against overheating and the motor against overloading. When
the LED indicator continuously lights up red, the temperature of the battery is too high and the machine switches off
automatically.
- Switch the power tool off.
- Allow the battery to cool down before continuing to work.
The LED indicator flashed red, the power tool is blocked and switches off automatically.
Remove the power tool from the workpiece.
The power tool will continue to work as soon as the blockage is rectified.
10) Protection Against Deep Discharging
The lithium-ion battery is protected against deep discharging by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective circuit: the inserted tool no longer rotates.
11) Switching on the LED Work area illumination
The power light ⑫ lights up when the On/Off switch② is slightly or completely pressed, and allows the work area to be
illuminated when lighting conditions are insufficient.
C. Working Advice
Protect saw blades against impact and shock.
Guide the machine evenly and with light feed in the cutting direction. Excessive feed significantly reduces the service life of
the saw blade and can cause damage to the power tool.
Sawing performance and cutting quality depend essentially on the condition and the tooth form of the saw blade.
Therefore, use only sharp saw blades that are suited for the material to be worked.
Sawing Wood
The correct selection of the saw blade depends on the type and quality of the wood and whether lengthway or crossway
cuts are required.
Guide in the base plate
Parallel guide