CAPTELEC S 7010 Mode D'emploi page 30

S 7010 /
CCS701-12
a. Recharge only with the charger specified by the manufacturer.A charger that is suitable for one type of battery pack
may create a risk of fire when used with another battery pack.
b. Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of
injury and fire.
c.When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails,screws or
other small metal objects, that can make a connection from one terminal to another. Shorting the battery terminals
together may cause burns or a fire.
d.Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush
with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or
burns.
5. Service
Have your power tools serviced by a qualified repair person using only identical replacement parts. This will ensure that
the safety of the power tools is maintained.
SPECIFIC SAFETY RULES FOR CIRCULAR SAWS
Cutting procedures
· DANGER: Keep hands away from cutting area and the blade. Keep your second hand on auxiliary handle,
or motor housing. If both hands are holding the saw, they cannot be cut by the blade.
·Do not reach underneath the workpiece. The guard cannot protect you from the blade below the workpiece.
·Adjust the cutting depth to the thickness of the workpiece. Less than a full tooth of the blade teeth should be
visible below the workpiece.
·Never hold piece being cut in your hands or across your leg. Secure the workpiece to a stable platform. It it
important to support the work properly to minimize body exposure, blade binding, or loss of control.
·Hold the power tool by insulated gripping surfaces only, when performing an operation where the cutting tool
may contact hidden wiring. Contact with a "live" wire will also make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
·When ripping, always use a rip fence or straight edge guide. This improves the accuracy of cut and reduces the
chance of blade binding.
·Always use blades with correct size and shape of arbour holes. Blades that do not match the mounting hardware
of the saw will run eccentrically, causing loss of control.
·Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially designed for
your saw, for optimum performance and safety operation.
Further safety instructions for all saws Kickback causes and related warning
--Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw to lift up
and out of the workpiece toward the operator.
--When the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction
drives the unit rapidly back toward the operator.
--If the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top
surface of the wood causing the blade to climb out of the kerf and jump back toward the operator.
Kickback is the result of saw misuse and/or incorrect operating procedures or conditions and can be avoided by
taking proper precautions as given below:
·Maintain a firm grip with both hands on the saw and position your arms to resist kickback forces.Position your
body to either side of the blade, but not in line with the blade. Kickback could cause the saw to jump backwards,
but kickback forces can be controlled by the operator, if proper precautions are taken.
·When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw
motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the
work or pull the saw backward while the blade is in motion or kickback any occur. Investigate and take corrective
actions to eliminate the cause of blade binding.
·When restarting a saw in the workpiece, centre the saw blade in the kerf and check that saw teeth are not
engaged into the material. If saw blade is binding, it may walk up or kickback from the workpiece as the saw is
restarted.