CAPTELEC S 7010 Mode D'emploi page 33

S 7010 /
CCS701-12
•Only use saw blades that correspond with t he characteristic data given in the operating instructions.
•Do not under any circumstances use grinding discs as the cutting tool.
Removal of the Saw Blade
For changing the cutting tool, it is best to place the machine on the face
side of the motor housing.
- Press the spindle lock button ⑧ and keep it pressed.
The spindle lock button ⑧ may be actuated only when the saw spindle
is at a standstill. Otherwise, the power tool can be damaged.
- With the hex key, unscrew the clamping bolt turning in rotation
direction.
Tilt back the retracting blade guard ⑰ and hold firmly.
- Remove the clamping flange and the saw blade from the saw spindle.
Mounting the Saw Blade
For changing the cutting tool, it is best to place the machine on the face
side of the motor housing.
Clean the saw blade and all clamping parts to be assembled.
Tilt back the retracting blade guard ⑰ and hold firmly.
Place the saw blade onto the mounting flange. The cutting direction of the teeth(direction of arrow on the saw blade) and
the direction-of-rotation arrow on the retracting blade guard ⑰ must correspond.
Mount the clamping flange and screw in the clamping bolt turning in rotation direction. Observe correct mounting position
of mounting flange and clamping flange.
Press the spindle lock button ⑧ and keep it pressed.
With the hex key, tighten the clamping bolt turning in rotation direction.
3) Adjusting the Cutting Depth.
Before any work on the power tool , remove the battery.
- Loosen wing bolt ④.
- Adjust the cutting depth to the thickness of the workpiece.
Less than a full tooth of the blade teeth should be visible below the workpiece.
For a smaller cutting depth, pull the machine from the base plate; For a larger cutting depth, push the machine toward the
base plate.
- Tighten wing bolt again. When setting the cutting depth, use the reference mark to the side of the cutting-depth scale.
4) Adjusting the Cutting Angle
It is best to place the machine on the face side of the blade guard.
- Loosen wing bolt ⑪.
- Tilt the saw sidewards.
- Adjust the desired setting at the scale.
- Tighten wing bolt again.
When setting the mitre angle, use the reference mark upper edge of the holder.
Note: For bevel cuts, the cutting depth is smaller than the setting indicated on the cutting-depth scale.
5) Cutting Marks
The 0⁰ cutting mark indicates the position of the saw blade for right-angled
cuts. The 45⁰ cutting mark indicated the position of the saw blade for 45⁰ cuts.
Hex key can be
found here: