Kemper MINI-TRESOR Instructions D'installation Et D'utilisation page 11

EN 1
Note!
The depth (D) min. 120 mm, max. 140 mm is calculated from the
wall thickness of the outer wall including installation, clinker etc.
Note!
In order to guarantee frost protection of the water fitting, a wall
thickness (1) of 150 mm is required.
Note!
When laying the connecting pipe within the wall, a minimum wall
thickness of 285 mm is required!
Note!
The valve must be attached minimum 250 mm over the maximum
of operating water surface!
Wall opening | Recess
A wall opening must be provided with
the dimensions 510 x 290 mm (H x W).
Heat insulation against the effects of cold from outside
Heat insulation must be provided for the wall opening in consultation with
the architect! (The thickness of the insulating layer must be taken into ac-
count accordingly for determination of the installation depth!)
Fire protection
The wall opening reduces the fire resistance duration and the structural
strength of the outer wall. A fire protection concept for the built-in wall
cabinet (1) must be produced together with the surveyor and fire-
safety planner (Suggestion for an F 90 wall: Use lagging with 40 mm
Promatect H).
© www.kemper-olpe.de – 11.2021 / K410021000001-00 – 11 /36