Checking The Seal - strapex STP 63 Mode D'emploi

Fig. 7
Fig. 8
min. 1 mm (.039")
Fig. 9
05.11
Sealing
– Press the yellow button (7/1) with the right thumb
until the strap is cut off.
1
– Raise the motor to the stop and swing the tool
away to the right.
– Check the seal (see chapter 6.2).
– Check the appearance of the seal at regular
intervals.
– To obtain the maximum seal effi ciency, the notches
have to be cut properly into the straps and should
interlock at least 1 mm (.039").
If these notches are not correctly cut, the dies and the
die plate have to be replaced (see chapter 7.6).
The cut-off depth must be adjusted so that the lower
strap is not damaged. For adjusting the cut-off depth
(see chapter 7.3).
Never transport or move packaged
goods with incorrect seal.

6.2 CHECKING THE SEAL

Strapex STP 63
19