Checking The Seal - strapex STR 64 Mode D'emploi

Strapex STR 64
Tensioning
– Press the green button completely down with the
thumb of the right hand. Release green button. The
strap is tensioned until the air motor stops.
The tensioning force can be infinitely
adjusted (see chapter 7.1).
Interrupting the tensioning process
– Press catch (7/2) to the right or tap-
ping yellow button (7/3) briefly, green
button rises and tensioning is interrup-
ted.
If the items to be strapped are mainly
delicate products, it is recommended to
remove the catch. The green button will then no
longer be locked when pressed down.
Sealing
– Press the yellow button (8/1) with the right thumb
until the seal is notched and the strap is cut off.
– Raise the motor to the stop and swivel the tool
away from the strapping to the right at the rear.
– Check the seal (see chapter 6.2).
Never transport or move packaged
goods with incorrectly notched seals.

6.2 CHECKING THE SEAL

– Check the appearance of the seal at regular inter-
vals.
– To obtain the maximum seal efficiency, the notches
have to be cut properly into the seal (Fig. 9/1).
1 Good seal (seal is evenly notched and the notches
are deep enough)
2 Poor seal (seal not notched deeply enough or the
seal is deformed or has sharp edges)
3 Poor seal (seal notched unevely)
If notching has not been carried out satisfactorily, per-
form new sealing with correct tool handling.
In case of faulty seals, the following parts subject to
wear must be replaced (see chapter 7.5):
– notcher
– jaws
– bolts
Use only original spare parts.
18
2 3
Fig. 7
Fig. 8
2
Fig. 9
1
3
12.11