Preventive And Corrective Maintenance; Adjusting Tensioning Force/Tensioning Speed; Setting The Cut-Off Depth - strapex STP 63 Mode D'emploi

Strapex STP 63
7
7.1 ADJUSTING TENSIONING FORCE/
TENSIONING SPEED
– Set air pressure at pressure reducing valve of
maintenance unit to 5–6 bar.
– With a screwdriver adjust pressure reducing valve
(10/1) of air motor, so that the motor stops when the
required tension is reached. It should be ensured
that the seal is notched properly and that the strap
is cut off.
A correctly punched seal is interlocked only
when the strap is tensioned.
7.2 SETTING CLEARENCE BETWEEN TENSION
WHEEL AND TENSIONING PLATE
– Disconnect tool from air supply.
– Set cylinder screw (11/1) with Allen key, so that the
clearance between tension wheel and tensioning
plate is approx. 0.3 mm (.012").
Turning clockwise increases the clearance, turning
counterclockwise decreases the clearance.
Tension wheel and tensioning plate must
not touch. If they are too far apart, the ten-
sioning wheel slips before the fi nal tension is reached.

7.3 SETTING THE CUT-OFF DEPTH

The setting of the cut-off depth must corre-
spond to the thickness of the strap used. If
the cut-off depth is not correctly adjusted
the seal effi ciency could be negatively
affected.
– Turn set screw (12/1) with screwdriver, so that the
lower strap (12/2) is not damaged when cutting
off. Turning clockwise reduces the cut-off depth,
turning counterclockwise increase the cut-off
depth.
20

PREVENTIVE AND CORRECTIVE MAINTENANCE

Fig. 10
Fig. 11
Seal
Fig. 12
1
1
1
2
05.11