Initial Operation; Suspending The Tool; Compressed-Air Connection - strapex STP 63 Mode D'emploi

5
Horizontally
Vertically
Sideways
Fig. 3
05.11

INITIAL OPERATION

The tool can be suspended on a spring balancer with
1 the suspension bracket (3/1) supplied. The suspensi-
on bracket is designed to operate the tool horizontally
or vertically or sideways.
Motor and sealing piston are lubricated by oil mist of
the compressed air. Properly prepared compressed air
is therefore essential for troublefree operation of the
tool. This can only be ensured by a reliably functioning
maintenance unit, consisting of water separator,
pressure reducing valve with pressure gauge and oil
mist lubricator.
The length of the hose between the OR-H 21 A tool
and the maintenance unit should not exceed 5 m
(15 ft). The internal diameter of the pipe should be at
least 10 mm (
does not form loops, where oil can collect.

5.1 SUSPENDING THE TOOL

5.2 COMPRESSED-AIR CONNECTION

/ "). It must be ensured that the hose
3
8
Strapex STP 63
17