Using The Rotisserie - SilverCrest SGBR 1500 D4 Mode D'emploi

Using the rotisserie

WARNING! RISK OF INJURY!
Always use the tongs w to insert the hot rotis-
►
serie z into the appliance or to remove it.
You can use the two skewer clamps t to fix the
■
food onto the rotisserie z. Loosen the restrainer r
on the skewer clamps t, push them so that the
food is fixed firmly in between the clamps and
then screw the restrainer r tight again.
First push the end of the rotisserie z without the
■
notch into the drive 1 (Figure 1):
Fig. 1: Push the rotisserie z into the drive 1.
Then insert the other end of the rotisserie z with
■
the deep groove in the spit fitting 9 (Figure 2):
Fig. 2: Insert the rotisserie z in the spit fitting 9.
SGBR 1500 D4
NOTE
Always slide the baking tray q into the lower
►
rail when you use the rotisserie z.
This will collect any drips.
To remove the hot rotisserie z, grip with
■
the hooks at the end of the tongs w into the
recesses on the rotisserie z (Figure 3):
Fig. 3: Hooking the tongs w onto the rotisserie z
First lift the left-hand side of the rotisserie z out
■
of the spit fitting 9 and then pull the rotisserie z
from the drive 1.
GB │ IE │
7 ■