Using The Extractor Hood - Dometic CK 2000 Instructions De Montage Et De Service

CK2000
7

Using the extractor hood

7.1 Switching the extractor hood on and off
➤ Switch the extractor hood on using the " " switch (fig. 2 2, page 4).
7.2 Switching the light on and off
➤ Switch the light on using the " " switch (fig. 2 3, page 4).
7.3 Tips for use
• Switch on the extractor hood a few minutes before starting to cook. This helps
the dome of air to form, which surrounds the steam and odours and allows them
to be extracted.
• Leave the extractor hood running for a few minutes after you have finished cook-
ing to ensure that any odours which are still in the air can be neutralised.
7.4 Cleaning the air filter
!
WARNING! Fire hazard!
An oversaturated grease filter which is no longer absorbent could cause
a fire. Clean the grease filter regularly.
The grease filter in the extractor hood must be cleaned regularly, as grease collects
there. How often cleaning is necessary depends on how often you cook and how
often the extractor hood is switched on. Do not wait until the performance of the
extractor hood deteriorates before cleaning the grease filter. The grease filter should
be cleaned every six months when subject to normal use.
The grease filter is fitted on the cover.
➤ Remove the two screws (fig. 7 1, page 6) from the cover and fold the cover
(fig. 7 1, page 6) downwards.
➤ Remove the grease filter from the holder (fig. 8, page 7) and clean it.
You can clean the grease filter by hand using a soft nylon brush, warm water and a
little detergent, or you can clean it in a dishwasher using a 65 °C washing cycle.
EN
Using the extractor hood
13