ECOFOREST Basic Manuel D'installation Et Maintenance page 42

6.12. If the reducer motor receives current and rotate slower than usually, it may have something blocked such as
a screw, a piece of wood, etc. To solve this problem, you must empty the hopper and, even if necessary, to
remove the auger screen.
6.13. If when the reducer motor rotates makes a noisy is due to a lack of lubrication- you have to lubricate only the
auger screen, not the reducer motor, see point 5.11.
PELLETS FALL BUT THE STOVE DOES NOT TURN ON:
6.14. Make sure the glass door is well closed.
6.15. Make sure the burn pot is correctly placed, that it is in contact with the resistance tube and the central hole
of the burn pot goes along with this tube.

Burn pot.

Burn pot support.

Resistance air inlet.

Resistance drive.

Start-up resistance.

Resistance tube support.

Screw of resistance.

Resistance support guide.

Resistance support tube, badly fixed.

Resistance support tube, badly fixed.

Start-up resistance, badly fixed.

Resistance support tube; badly fixed.
6.16. Pay special attention to the cleaning of the stove as excess of dust may prevent the stove from starting on.
Drawing 30
41
Drawing 31