Télécharger Imprimer la page

ECOFOREST Basic Manuel D'installation Et Maintenance page 29

Poêle

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 46
4.
INSTALLATION.
The below security distances and assembly diagrams are given for information only as an adaptation shall be
made depending on the norms in force regarding gas outlet, power, security minimum distances specific to
geographic areas.
The installation of the stoves must be done in the same way, for this reason, only the VIGO II model will be
exposed. In the same way, air inlets will be missed in all drawings as section 4.17 indicates the minimum security
distances to be respected for their installation.
The power socket to which the stove is plugged should meet the following requirements:
4.1.
Ground connection must comply with the specific applicable regulations.
4.2.
Differential switch with the correct amperage. It must comply with the specific applicable regulations (check
technical specifications of the stove).
4.3.
Single-phase AC of ~230/240V – 50Hz and pure sine wave.
4.4.
The plug must only be connected to a socket with the technical characteristics of the plug in question.
4.5.
Easily accessible power socket. If the power socket can't be accessed due to the characteristics of the
electrical installation, an all-pole disconnection switch must be installed.
4.6.
The power cable provided by ECOFOREST is 1.4m long; you might need a longer one. Always use a cable with
ground plug and with an equal or greater section. Make sure the power cable is not placed under the stove
or close to hot or sharp surfaces that could damage it.
4.7.
Remove the packaging and the protective plastic.
4.8.
Remove the screws or bolts that fasten the stove to the pallet and remove it.
4.9.
If our model has a plastic protection, it must be removed before starting it.
4.10. Remove exhaust blower protection ().The Monaco model has 3 gas output possibilities.
Airtight installation (Moon, keops and Lyon): Remove protection from the air intake pipe (  ).
Mónaco airtight installation: Fit adapter to Ø60mm.
Adapter Ø 30-60mm (Code: SP0039AA).
ELECTRICAL CONNECTION.
UNPACKING THE BOILER.
Drawing 4
28
Drawing 5

Publicité

loading

Ce manuel est également adapté pour:

MoonVigo iiLyonMonacoKeopsBasic