Conveyor Belt Adjustment; Air Flow Adjustment; Reel Support And Packaging Plate Adjustment - Minipack-Torre Media Matic Instructions Pour L'installation, L'emploi Et L'entretien

Chapter 6. Machine adjustment and setting up EN

6.3. Conveyor belt adjustment

Adjust the height of the conveyor belt with the special
handwheel.
In order to get a good packaging the conveyor belt
should be positioned in such a way, that the film
welding is made at half the packaging height.
Adjust curtains acting placed on tunnel inlet on the
proper knobs (6) to get them at the same level of tunnel
belt.

6.4. Air flow adjustment

It is possible to adjust the air flow on the product to
pack by acting on the knobs (7).
The rotation of knobs determines the position of the
flaps (8) which drive the hot air flow into the desired
direction so to obtain the best shrinking.

6.5. Reel support and packaging plate adjustment

The reel support (3) and the packaging plate (5) must
be adjusted according to the width (a) of the article to
be packaged, leaving a space of about 1-2 cm between
the article and the sealing edge.
25