Minipack-Torre Media Matic Instructions Pour L'installation, L'emploi Et L'entretien page 20

Chapter 4. Safety standards

Ensure that all clothing is tight fitting, with particular reference to cuffs or other loose clothing.

Ensure that all operating areas and transit zones are kept clear, clean and adequately lit at all times.

Eliminate all safety hazard conditions before using the machine and always notify the head personnel of any
malfunction.

Never use the machine in the event of fault.

Never tamper with safety devices or circuits.

Never perform modifications on the machine without prior authorisation from the manufacturer.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.

The electrical enclosure must remain closed during operation.

Smoking is forbidden while the machine is operating!

Never performs maintenance and/or adjustments to the machine during operation. Guards may only be
disassembled by suitably trained and qualified maintenance engineers.

Never operate the machine without all guards fitted. Ensure correct position of all guards before resuming normal
operation.

If it is necessary to leave the machine unattended, switch it off by turning the main switch to the "0" (OFF) position!

The manufacturer declines all liability for damage or phisical injury caused by failure to observe safety standards.
THE MACHINE CAN NOT BE USED BY UNTRAINED PERSONNEL!
During the work phases pay attention to all hot parts of the machine. The temperature they can reach is so
high that it can cause burns.
In case of blocking of the machine or in order to stop it during the automatic cycle press EMERGENCY
PUSHBUTTON (S0).
Before starting the automatic cycle, make sure that all necessary adjustments have been made.

All adjustments of the machine will be made by the selector (S2) in "MAN." position.

Do not touch the sealing blade (19) soon after

sealing by reaching beyond the safety guard.
Danger of burns due to residual heat on the
sealing blade.
Do not keep on sealing in case the sealing

blade (19) breaks. Replace it at once.
Do not place your hands inside the retraction

tunnel (12). Possible burns.
Do not touch the conveyor belt (26) when it is in

motion.
Make sure the film reel is properly lodged in is

place (31).
The wheels (30) must be used only for moving

the unit short distances
horizontal floors.
across smooth,
19
EN