Publicité
Les langues disponibles
Les langues disponibles
5. Press the ON button to start warming cycle. The indicator light illuminates in red color. CAUTION! The steam given off during
the warming cycle is very hot. Keeps your hand off the appliance when operation.
6. When the heating cycle finished, bottle warmer will switch off automatically. At the same time, there will be a "beeping"
sound to remind you the bottle is done.
7. Then you can take out the bottle. For baby food jar, use the handle of Food Jar Tray to take it out. You can then unplug
the unit.
For using in car:
Stop the car / vehicle and keep the engine running.
8. Place the Bottle Warmer on a flat and stable surface inside your car and vehicle. Connect the Car Adaptor Plug on to the
power cord of the bottle warmer.
9. Plug the Car Adaptor Plug into the cigarette socket. You can see the indicator light illuminates in green color. Fill the measuring
cup with water, following the instructions shown above, then pour the water into the heating chamber. Your can then
place the cup back to the holder.
Repeat steps 2 – 7
as above.
Cleaning the bottle warmer:
- Always unplug the appliance and wait until it is cool before cleaning it.
- Use a damp cloth to clean the inside and outside of the unit.
- Never immerse the unit in water.
- Do not use abrasive products to clean.
- Adapter ring, trays and measuring cup can be washed using a sponge with soap and water or can be cleaned in the
dishwasher in the top tray.
Descaling the tank:
According to the quality of the water used, a limescale deposit can build up on the bottom of the heating chamber over
time. You should regularly descale your bottle warmer by pouring a mixture of 100 ml of hot water + 100 ml of white
vinegar into the heating chamber.
Leave this to act for approximately 30 minutes before emptying the chamber and wipe with a damp cloth. Do not use detergent
to clean.
• The bottle warmer doesn't heat up:
- check that the appliance is plugged in.
- check the "On" button to make sure it is properly switched on.
• The warming cycles are too short or too long:
- there is not enough or too much water; be sure to use only the amount indicated.
8
Amount of content
in bottle
60 ml
90 ml
120 ml
150 ml
180 ml
210 ml
240 ml
270 ml
300 ml
330 ml
CLEANING THE BOTTLE WARMER
IN CASE OF ANY LITTLE PROBLEMS
BOTTLE WARMER AT HOME OR IN THE CAR • Instuction Manual
Quantity of water
to be put in the
measuriong cup
4 ml
5 ml
5 ml
5 ml
5 ml
5,5 ml
5,5 ml
6 ml
6,5 ml
6,5 ml
Quantity of water
Weight of
baby jar
measuriong cup
120 g
200 g
250 g
to be put in the
9 ml
12 ml
14 ml
Publicité
