dirna Bergstrom bycool COMPACT ADR Instructions De Montage page 30

COMPACT
EN
Detailed instructions on power wiring assembly
Open the cover of the upper right glove box and
1
remove the two screws of the lower side. (1a)
1
1a
Separate slightly the glove box and introduce
2
the hand trough the bottom side to pick up
the original wiring. This wiring loom comes
protected by a 40 amps. fuse existing in the
original central fuses box.
If the connector for the existing wiring is
!
already in use (for example, if connected to
a microwave), add a new cabling connector,
similar to the existing one in the box, from the
glove compartment to the central box.
Protect the cable supplying the current with a
separate new 40A fuse. (Keep the 40A fuse in
the central fuse box).
Route the unit wiring between the roof and
3
the upholstery up to the glove box and plug
both connectors. Once connected, the unit
will carry out a checking function, all leds will
enlight and turn off, that means the unit is
ready to start.
Fix unit wiring loom to aluminium bracket as
shown in picture, using plastic strips.
IMPORTANT REMARK
In the case that, for a mistake, the wires were shifted inverting the polarity, the electronic
control of the unit would start to emit intermitent beeps. In that case, do not touch any of
the buttons of the control panel neither the remote control, because the electronic control of
the unit could result electronic system with irreversibly damages. Please, consult the User´s
Guide before starting the unit.
All models except Euro 6
With access by right glove compartment
1
2
3
30
Air conditioning for vehicles