Timer - Novy Flex Zone 1706 Mode D'emploi


Start up / Stop Super Power function:
Action
Selection of the zone
Start up Power
Start up Super Power
Stop the Super Power
 Power management
The hole cooking hob is equipped by a maximum of power. When the booster function is
activated, and not to exceed the maximum power, the electronic system orders to reduce
automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a
few seconds and then shows the maximum of power allowed ( [ 6 ] or [ 8 ] ).
Heating zone selected
[ P ] is displayed

Timer

The timer is able to be used simultaneous with all 4 heating zones and this with different time
settings (from 0 to 99 minutes) for each heating zone.
 Setting and modification of the "Egg Timer"
The "Egg Timer" is independent from the heating zones. If this timer is on and you stops the
hob, the "Egg Timer" will continue until the end of the time.
Action
To start:
To select the "Egg Timer"
Decrease the time
Increase the time
When the time reaches [00.] it is blinking and beeping.
 To stop the "Egg Timer"
Action
To select the "Egg Timer"
To stop the "Egg Timer"
 Setting and modification of the cooking time of a heating zone
Action
To select a heating zone
To select the power level
To select the « Timer »
Decrease the time
Increase the time
The time is configured and the cooking starts until the time reaches [00].
Control panel
Press key [ + ] or [ - ]
Press key [ P ] then [ + ]
Re-press key [ P ] then [ + ]
Press key [ - ]
The other heating zone:
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
Touch the key [ 0/I ]
press once on timer key
[ - ] and [ + ] simultaneously
Press on timer key [ - ]
Press on timer key [ + ]
Control panel
Press once on timer key
[ - ] and [ + ] simultaneously
Press on timer key [ - ]
Press second time on
timer key [ - ]
Control panel
Press on key [ + ]
Press on key [ + ] or [ - ]
Press on timer key [ - ] and [ + ]
simultaneously until the
desired heating zone.
Press on timer key [ - ]
Press on timer key [ + ]
49
Display
[ 4 ] or [ 9 ]
[ P ]
[
[ 9 ]
(example: power level 9)
Display
[00]
[30] wents to 29,28,27,
the time increases...
Display
the time displays
displays [01]
displays [00]
Display
[4]
[1] to [9]
timer control light
from the desired
heating zone is on
[30] wents to 29,28..
the time
increases...
and P ]
[ 0 ]