Side Cutter - Singer MADAME 2 Manuel D'instructions

EN

Side Cutter

Lift the presser foot lifter (a) to raise the presser foot bar. (1)
Remove the presser foot. (
Attach the Side Cutter to the machine as follows (2):
- Insert the arm (b) to the needle clamp (c).
- Lower the presser foot lifter while making sure the pin (d) of
the side cutter fits the presser shank (e) and is secured in
place.
Cut an edge of fabric about 2~3 cm. (3)
Put fabric on guide plate (f) and push left side of the fabric to
go below presser foot (g). (2/4)
Thread the needle and pull back upper and lower threads
under presser foot and put them to the direction of feeding.
Run machine slowly and start sewing from the below of the
needle.
Adjust the stitch width and the stitch length according to
stitch selected.
For very thin fabric, loosen the tension of upper threads as
well as the pressure of presser foot shank. Guide the fabric
by your finger not to slide aside.
Note:
The side cutter can only be used with the regular zigzag
stitch or the overlock stitches.
See page 49 )
1
2~3 cm
3
45
a
d
g
2
4
b
c
e
f