Setting The Thresholds; Programming The; Initial Angle Of Inclination (Optional) - Centronic SensorControl SC211-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Attention
A threshold must be set which does not exceed the maximum permitted
load for the folding-arm awning.
1) Extend the folding-arm awning to the limit position.
2) Position the threshold regulator on the SWC241-II in the middle.
3) Grasp the front section of the folding-arm awning and shake it in a way that
represents the force at which you want the folding-arm awning to retract, for
at least 10 seconds.
4) If the folding arm awning remains extended, the wind threshold must be set
to a more sensitive setting; then repeat the test.
5) If the folding-arm awning retracts fully, the threshold is at the correct
setting.
Note
The folding-arm awning must not be extended for 15 seconds after re-
traction.
initial angle of inclination (optional)
Note
The folding-arm
programming the initial angle of inclination.
1) Extend the folding-arm awning to the limit position.
2) Turn off the power to the system.
3) Open the SC211-II.
4) Press the programming button for at least 10 seconds until the LED goes from
green to red briefly and then back to green.
5) Close the SC211-II.
6) Now turn the power to the system back on.
This completes the programming process.
26
4. Setting the thresholds
5. Programming the
awning must be completely still when