Intended Use - Centronic SensorControl SC211-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
The SC211-II is designed solely for the operation of folding arm awnings. It can
be integrated in an open awning, in a half cassette or a fully closing cassette
awning. For safety reasons, the SC211-II may only be operated with one sun
protection drive with integrated radio receiver. The operation of two or more
awnings with one SC211-II is not permitted.
The SC211-II is compatible with the Centronic SunWindControl SWC241-II hand-
held transmitter. The use of other sun protection controls from the Centronic
range to operate the SC211-II is not recommended.
Using the SC211-II for other purposes or for purposes beyond the above
constitutes improper use.
• Please note that radio-controlled systems may not be used in areas with a
high risk of interference (e.g., hospitals, airports).
• The remote control is intended solely for use with equipment and systems in
which malfunctions in the hand-held transmitter or receiver would not pose
any risk to persons, animals or property or which contain safety devices to
eliminate such risks.
• The operator is not protected from interference from other telecommuni-
cations systems and terminal equipment (e.g., even from radio-controlled
systems which are properly operated in the same frequency range).
• An awning with hinged brackets cannot be protected of sudden wind gusts.
Please make sure that the awning stays closed during those risky weather
periods.
Note
Radio-controlled systems transmitting on the same frequency may
cause reception interference.
Note that the range of the radio signal is limited by legislation as well
as by design.
20
Intended use