Setting The Release Angle (Optional) - Centronic SensorControl SC211-II Notice De Montage Et D'utilisation

Caution
It is important to follow steps 1-5 in the correct order.
1. Setting the release angle (optional)
Caution
The release angle may only be set by a specialist in accordance with the
specific features of the folding-arm awning.
1) Open the SC211-II and remove the PCB.
2) Set the release angle on the threshold control switch.
3) Slide the PCB back into the SC211-II and close the cover.
4) This completes the setting process.
The factory default is 0 (off).
Note
The release angle setting is applied once the initial angle of inclination
is set (Section 5).
de
en
fr
nl
23