Publicité
Les langues disponibles
Les langues disponibles
Open source
The high-pressure washer can be used with a
suction hose with a check valve to take water
from a barrel, or pond.
NOTE:
Impurities in the water can damage the high-
pressure pump and accessories.
1.
Fill the suction hose with water.
2.
Connect the suction hose to the water
inlet on the product and put the other
end in the water (e.g. rainwater barrel).
3.
Vent the high-pressure washer as follows
before use:
1.
Start the product with the power switch.
2.
Unlock the spray gun catch.
3.
Press the trigger. The product starts
working.
4.
Allow the high-pressure washer to run
until water without bubbles comes out
through the nozzle.
NOTE:
Do not run the high-pressure washer
without liquid for more than 2 minutes,
this will damage the high-pressure pump.
If the pressure is not sufficiently high within
2 minutes, switch off the high-pressure
washer and follow the instructions in the
troubleshooting guide.
5.
Lock the spray gun with the catch.
HIGH-PRESSURE WASHING
IMPORTANT:
•
Hold the nozzle at least 30 cm from
painted surfaces when cleaning to avoid
damage.
•
Check that the power switch is in the off
position and plug the plug into a
correctly installed power point.
NOTE:
The high-pressure washer should be placed
upright on a level, stable surface when in use.
FIG. 10
1.
Connect the water supply and plug in the
plug.
2.
Open the water tap.
3.
Hold the spray gun firmly with both
hands.
4.
Point the nozzle at the surface to be
cleaned.
5.
Unlock the trigger and press until a
continuous jet flows through the nozzle
and brings with it any air from the hose.
6.
Release the trigger.
7.
Put the switch in the ON position.
8.
Hold the spray gun firmly with both
hands. Point the nozzle at the surface to
be cleaned and press the trigger.
9.
Release the trigger to stop the jet, and
switch off. The high-pressure washer is still
charged with high pressure.
WARNING!
Watch out for kickback when pressing the
trigger.
DURING A PAUSE IN THE WORK
1.
Release the trigger.
2.
Lock the spray gun with the catch.
3.
Put the spray gun with the spray head in
the storage position.
4.
Switch off the high-pressure washer with
the power switch if it is not going to be
used for 5 minutes or more.
EN
39
Publicité
