Medoc STL-350F Manuel D'utilisation page 7

a. Unscrew the cover cap (16) so that you have access to the equaliser grub screw (14) and the hollow screw (15).
b. Unlock the equaliser grub screw (14) releasing the hollow screw (15).
c. Turn the grub screw (14) towards your right if you want to backward the blade, and towards your left if
you want to forward the blade.
d. Turn round with your hand the top pulley to the right and make sure the blade position is correct. In the
case that the machine is provided with cutting on the left hand, proceed in the opposite manner
e. Holding on to the grub screw (14), fasten tighten the hollow screw.
f. Turn on the machine for a few seconds and verify the correct position of the blade. If it is not correct,
go over the steps mentioned again, as many times as necessary.
g. Screw the cover cap (16).
8.3. Lubricating
The thickness top rail.-guide (10) and the carriage rail.-guide (19) must be lubricated
It is also necessary to lubricate the rail guides and the feather of the tension device, which are located
behind the top pulley. Use paraffin oil.
The rest of the machine should not be lubricated.
9. SOUND LEVEL
The band saw maintains an acoustic level under the 70 decibels.
10. TROUBLE SHOOTING
10.1. Problem: The band saw does not start.
a. Damaged plug.
b.
Incorrect voltage.
c.
Other cases.
10.2. Problem: A slow engine start or overheat.
Incorrect voltage.
10.3. Problem: Product does not cut well enough. Tail on uncut product.
Unsharpened blade.
10.4. Problem: The blade turns on the wrong way.
Defective connection.
11. LIABILITY
No liability will be accepted when the damages caused by inadequate use, defective handling,
structural modifications, removal of the protection devices or use of spare parts which are not from the
manufacturer. The seller will not be liable to the buyer when the damages are caused to a natural wear
out of the machine.
A wrong use of the machine, as well as to use it to cut not food products, increases the risk for the
operator. The seller will not be responsible in case of a bad use of the bandsaw.
12. MACHINE GENERAL DIMENSIONS:
See page 6, 7, 8 and 9.
13. TECHNICAL SPECIFICATIONS
Motor........................: III (3Ph): 3HP,4HP,5,5HP, 230/400V, 50HZ
WARNING: These specifications could change for some countries due to special voltages. Verify the rating
plate of the machine before plugging it.
Safety devices: Blade stop before 4 seconds. Buttons and safety devices on low tension. Interlocking door
system. On/off switch, non-voltage release.
Finish......................: Stainless steel.
→ → → → Check the plug cables.
→ → → → Verify the plug voltage with the machine voltage.
→ → → → Call the distributor authorised.
→ → → →
Verify the plug voltage with the machine voltage. See section 15 if you
need to change the voltage.
→ → → → Change the blade.
Check that the teeth of the blade are facing up.
→ → → → See section 16.