Open Window Detection, Energy Savings - RADSON PTC BLOWER 950W Notice D'utilisation

Viewing the programmes that you have selected
- From Auto, Comfort, Eco or Frost protection mode, press
seconds. Press twice, the programme for each day of the week
(Comfort, Eco, P1, P2 or P3) will scroll on display in front of you.
- To exit the programme viewing mode, press
Manual and temporary exemption from a running
programme
This function allows you to change the setting temperature tempora-
rily until the next scheduled change in temperature or the transition to
0:00.
Example:
1- The device is in Auto mode, the running programme is Eco 15,5°C.
3
2- By pressing or , you can change temporarily the desired
temperature up to 18°C for example.
3
Note: The cursor corresponding to the operating mode, i.e Eco mode in
our example, is blinking during the duration of the temporary deroga-
tion.
3- This change will be automatically cancelled at the next change of
programme or transition to 0:00.
3
OPEN WINDOW DETECTION, ENERGY
SAVINGS
Important information about the open window detec-
tion
Important: the open window detection is sensitive to temperature va-
riations. The device will react to the window openings in accordance
with different parameters: temperature setting, rise and fall of tempe-
rature in the room, outside temperature, location of the device...
If the device is located close to a front door, the detection may be dis-
turbed by the air caused by opening door. If this is a problem, we recom-
mend that you disable the automatic mode open window detection
page 17). You can, however, use the manual activation (see below).
for 5
twice.
Overview
Lowering temperature cycle by setting frost protection during venti-
lation of a room by opened window. You can access the open window
detection from the Comfort, Eco and Auto modes. Two ways to enable
the detector:
- Automatic activation, the lowering temperature cycle starts as soon as
the blower detects a temperature change.
- Manual activation, the cycle of lowering temperature starts by pres-
sing a button.
Automatic activation (factory settings)
To disable this mode,
The device detects a temperature fall. An opened window, a door to the
outside, can cause this temperature fall.
Note: The difference between the air from the inside and the outside
must cause a significant temperature fall to be perceptible by the device.
This temperature drop detection triggers the change to Frost Protection
mode.
Manual activation
By pressing
5 seconds, the device will switch
on Frost protection mode.
Frost protection digital meter
When the device performs a lower temperature cycle due to opened
window, a meter appears on the display to show the cycle time.The
counter is automatically reset at the next time to Frost protection by
opened window (automatic or manual activation).
Stop the Frost protection mode
By pressing one button, you stop the Frost protection mode.
Note: if a temperature rise is detected, the device may return to the pre-
vious mode (active mode before the open window detection).
(see
2
Legend
= the favoured
= another location
see page 16.
for more than
M16MI328 A04_02/18 R
EN
1
location
9