RADSON PTC BLOWER 950W Notice D'utilisation page 12

EN
OPTIONAL: REMOTELY MANAGEMENT BY RF
REMOTE CONTROL
• Overview
Your device can be managed by a wireless RF remote control.
• RF pairing between the remote control and the blower
The remote control and the blower are not bonded together at the
factory, then proceed as follow:
1- From Frost protection mode, press
2- The blower is in pairing mode.
Then proceed to the remote control pairing (Same procedure, from
the frost protection mode, press for 5 seconds «Ok» The remote
control is then in pairing mode).
3- When both blower and remote control are linked, the
pears and is constantly displayed. The blower returns automatically
to the frost protection mode.
• Check the RF signal strengh
You can check at any time the RF transmission performance between
the blower and the remote control.
To view the RF reception level, from Frost protection mode, press
for 5 seconds. Then the level appears on the display.
1 = Low RF transmission level:
To improve the RF transmission performance between the 2 de-
vices and ensure the remotely management is optimized:
- Please ensure the RF transmission is not interrupted, move the
M16MI328 A04_02/18 R
for 5 seconds.
5 sec.
symbol ap-
5 sec.
remote control.
- Move the remote control closer to the blower.
10 = High RF transmission level, the location of the remote control is
optimized.
• RF pairing cancellation
You can cancel at any time the RF transmission between the blower and
the remote control.
From Frost protection mode press simultaniously on
5 seconds.
5 sec.
The symbol disappear from the display, the remote control and the
blower are not associated.
and for
12