Safety Information; Symbols On The Device - Deltafox DG-ECS 1830 Traduction De La Notice D'utilisation Originale

GB
Vibration a ...max. 5.79 m/s
h
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value
may differ during actual use of
the power tool from the stated
value depending on the manner
in which the power tool is used.
Safety precautions aimed at
protecting the user should be
based on estimated exposure
under actual usage conditions
(all parts of the operating cycle
are to be considered, including,
for example, times during which
the power tool is turned off and
times when the tool is turned on
but is running idle).
Technical and optical changes can be
carried out in the course of further devel-
opment without notice. All dimensions,
references and information of this instruc-
tion manual are therefore without guaran-
tee. Legal claims, which are made on the
basis of the instruction manual, cannot
thus be considered as valid.
This device is designed for oper-
ation on a power supply network
with a system impedance Zmax
at the transfer point (domestic
connection) of a maximum of
0.335 Ohms. The user must en-
sure that the device is operated
only on a power supply network
30
; K = 1.5 m/s
2 2
that fulfils this requirement. If
necessary, the local power sup-
ply company can be asked for
the system impedance.

Safety information

This section describes the basic safety
rules when working with the device.
Before working with the electri-
cal chainsaw, familiarise your-
self with all the controls. Prac-
tise handling the saw (by cutting
logs to size on a sawhorse) and
have the functionality, mode
of action, sawing techniques
and personal safety equipment
explained to you by an experi-
enced user or an expert.

Symbols on the device

Observe! Danger!
Read and take note of the operat-
ing manual belonging to the ma-
chine!
Wear personal protective
equipment. Basically, wear
protective goggles or, even
better, face protection,
safety helmet, cut-pro-
tection working clothes,
cut-protection gloves, cut-
protection safety boots
with anti-slip soles and ear
protection.
Caution! Spring-back - Be care-
ful of spring-back of the machine
during work.