Ryobi P3500 Manuel D'utilisation page 7

NOTICE:
Do not use the head assembly if any of the wheels or
brushes are broken or missing. Broken or missing parts
could tear the lining of the pool. Refer to the Maintenance
section for replacing parts.
Vacuuming without the head assembly:
For spot cleaning, steps, seats, or other tight spaces the head
assembly cannot reach, the vacuum can be used without
the head assembly.
NOTICE:
Spa water temperature must be at ambient temperatures
before submerging vacuum into water.
 Remove the head assembly and nosepiece by pulling the
nosepiece from the vacuum.
 Start the vacuum and lower into water until the vacuum
is completely submerged.
 Slowly move the vacuum along the floor, steps, or seats
of the pool or spa.
REMOVING WASTE FROM THE COLLECTION
CONTAINER
See Figures 8 - 10, pages 10 - 11.
The collection container should be checked, emptied, and
cleaned periodically for maximum efficiency.
OPERATION
WARNING:
Keep proper footing and balance at all times. The total
weight of the vacuum will increase when it is full of water
and wet debris. Failure to do so could cause loss of control
and injury to yourself and others.
 Lift the vacuum from the pool with the nose facing down.
 Turn the vacuum off when it is out of the water.
 With one hand holding the handle, pull up on the collec-
tion container handle until you feel the lock release and
the handle moves upward freely.
WARNING:
Never open the collection container with the vacuum
running. Opening the collection container with the
vacuum running could result in debris to be thrown at the
operator and cause serious personal injury.
 Empty the collection container; rinse out if necessary.
 Inspect filter. Rinse or replace as necessary.
 Replace collection container and lock securely.
7 — English