Publicité
Les langues disponibles
Les langues disponibles
To turn on and preheat the plate, just switch on the burner by pressing on the power
control knob (n°1 on picture) opposite the high flame position for a few seconds. Use
a gas lighter or a long matchstick by holding it near the burner and keeping the knob
pressed (n°1 on picture) for a few seconds. Then the burner remains lit, set the ma-
chine in desired power.
While cooking, the temperature can be regulated using the control knob (n°1 on pic-
ture) from high flame to low flame in order to avoid over-cooking. If the crepe sticks, it
is because the crepe machine is too warm, it is then necessary to reduce the power.
There is a double security :
If one of the branches of the burner is turned off by a draft, the star located in the mid-
dle of the burner will act as a flame diffuser towards the extinguished branches
(patented system). A safety thermocouple cuts the gas supply if the burner is extin-
guished. The low flame of the appliance is pre-adjusted in the factory, it must not be
changed.
1
Control knob
1
5. FUNCTIONING / HANDLING
a) Installation/Assembly:
- Unpack carefully the machine from its packaging.
- Place it on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible materi-
als even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
13
Publicité
