Publicité
Les langues disponibles
Les langues disponibles
4.1.4
Motor setting
Through the Motor Setting page you can control the polar axis motor to adjust the direction of antenna so as to make the antenna accurately
point to the satellite. There are these setting items in this page (see Fejl! Henvisningskilde ikke fundet.
Satellite:
Satellite: Select a satellite.
Satellite:
Satellite:
•
Transponder:
Transponder: Select a transponder.
Transponder:
Transponder:
•
Motor setting: Set the polar axis motor.
Motor setting:
Motor setting:
Motor setting:
•
If you have already selected a satellite and a transponder, when moving the polar axis you will find the signal strength and quality indicators at
the bottom of the page..
4.1.5
Limit setup
There are three sub items:
Limit Setup:
Limit Setup: Polar axis move limit setting.
Limit Setup:
Limit Setup:
•
Continuing Move: Enable polar axis continuous move.
Continuing Move:
Continuing Move:
Continuing Move:
•
Move Step: Enable polar axis step move. After setting, you can press V+/
Move Step:
Move Step:
Move Step:
•
4.1.6
Search example
Press MENU
MENU key to enter the Main Menu and then directly press OK
MENU
MENU
•
in the pop-up dialog to enter the Installation menu.
Enter the Satellite List item. If there are satellites, press CH+/
•
a green check mark appears. Press the blue function key to pop out the Search menu and then press OK
system will then start to auto scan.
EN
Fejl! Henvisningskilde ikke fundet.):
Fejl! Henvisningskilde ikke fundet.
Fejl! Henvisningskilde ikke fundet.
V+/- - - - keys to move the polar axis east or west step by step.
V+/
V+/
OK key. Key in a correct four-digit password (default password: 0000)
OK
OK
CH+/- - - - keys and OK
CH+/
CH+/
OK key to select a satellite. Before the selected satellite name,
OK
OK
22
User manual
OK key with default settings. The
OK
OK
Publicité
Chapitres
