Pioneer PDK-FS02 Mode D'emploi page 14

Installation and assembly instructions
7
Fit glass panel into glass stays.
Note
The glass panel should be installed with the warning label
facing upwards.
Glass panel
8
Fix it with the screws (M4 x 10 mm) (2 locations: left
and right).
Be sure to use the screws to fix the glass panel into
place. Note that failing to do so could cause the
glass panel to fall off if you come into contact with
Caution
it and result in the panel breaking.
14
En
Caution
label
Support
column
Philips screwdriver
Base
9
What to do when attaching an upright media
receiver.
1 Fit the MR holder over the sides of the media receiver and
fix into place using the four screws (M4 x 12 mm) provided
for use in attaching the receiver to the receiver stand.
Note
The legs of the MR holder are on the side of the holder
with the indentations. Be sure to attach the holder in the
correct direction.
Do not attach the MR holder to anything other than a
media receiver.
MR
holder
Indentations
Media
receiver
2 Fit the legs of the MR holder over the upright slots of the
MR holder bracket and fix into place with screws (M4 x 8
mm).
Note
Do not attach any other equipment other than a media
receiver in this location.
Never place vases, dehumidifiers, or any other objects or
devices with liquids in them on top of the PDP bracket.
MR holder
Upright slot
Screw
(M4 x 8 mm)
Screws (M4 x 12
mm) for use in
attaching the
receiver to the
receiver stand.