Hitachi NT 50AE Mode D'emploi page 22

English
5. WARNING LABEL
Change the WARNING LABEL if missing
or damaged.
A new WARNING LABEL is available
from a Hitachi authorized service center.
SERVICE AND REPAIRS
● Only service personnel trained by Hitachi, distributor or em-
ployer shall repair the Nailer.
● Use only parts supplied or recommended by Hitachi for repair.
All quality Nailers will eventually require servicing or replacement of parts because of wear
from normal use.
NOTE:
Specifications are subject to change without any obligation on the part of HITACHI.
Maintenance chart
ACTION
Drain air line filter daily.
Keep lubricator filled.
Clean filter element — then Prevent clogging of filter
blow air through filter in
direction opposite to
normal flow.
Clean magazine and feeder Prevent a jam.
mechanism.
Keep push lever working
properly.
Lubricate the Nailer after
nailing.
Drain air compressor.
22
WARNING
WHY
Prevent accumulation of
moisture and dirt.
Keep the Nailer
lubricated.
with dirt.
Promote operator safety and Blow clean daily.
efficient Nailer operation.
Extend the Nailer life.
Keep the Nailer operated
properly.
Warning Label
HOW
Open manual petcock.
Fill with Hitachi pneumatic
tool lubricant.
Follow manufacturer's
instructions.
Blow clean daily.
Supply 2 – 3 drops of
lubricant into the Nailer.
Open petcock on air
compressor tank.