Quick QCC-LCS TS 4.3 Mode D'installation Et D'emploi page 19

QCC-LCS TS - REV002A
How do you want to call this room?
MAIN SALOON
Q W E R T
A S D F G
Z X C V
1,2,3.. space
After naming the room, proceed to associate the light zones of the room with the digital buttons.
MAIN SALOON
Find zone
Find zone Find zone
The following screen shows the maximum number of connectable zones, divided by intervals.
The procedure guides the user in the identification of a zone in 4 steps, by means of an exclusion procedure.
Searching zone
1-16
34-48
Searching zone
1-4
9-12
Searching zone
5
7
QUICK SPA
Y U I O P
H J K L
B N M
reset
OK
Find zone
Find zone
OK
17-32
49-52
OK
5-8
13-16
OK
6
8
OK
1.1 Room creation
Create a new room by naming it using the digital keyboard
(e.g., MAIN SALOON, KITCHEN, BATHROOM, HALL, etc.).
Confirm by pressing "OK".
1.2 Button selection
Select a Find zone box using the digital buttons,
(the selected box will have a white frame).
Confirm by pressing "OK".
F
You can select the Find zone boxes
in the order you prefer.
Key makes additional zones available.
1.3 Searching zone
Select a range of zones (e.g., 1-16),
(the selected box will have a white frame).
Check to see if the lights in the area are flashing.
If the area responds, confirm by pressing "OK".
F
If the lights prompted do not flash, try searching for
other groups of zones (17-32 • 34-48 • 49-52).
1.4 Searching zone
Select a range of zones (e.g., 5-8),
(the selected box will have a white frame).
Check to see if the lights in the area are flashing.
If the area responds, confirm by pressing "OK".
1.5 Searching zone
Select a zone (e.g., 5).
(the selected box will have a white frame).
Check to see if the lights in the area are flashing.
If the area responds, confirm by pressing "OK".
19
CONFIGURATION
EN