Abus FU8403 Instructions De Montage Et D'utilisation page 12

4. Teaching one detector (Submenu LED 01):
a) Press SELECT key 1 once: Main menu
b) Press SET key 2 once: Submenu LED 01 (teach alarm) opens
(if no alarm has been taught, LED 01 is always shining green). Zones already occupied flash red and cannot
be selected with the SELECT key. If no more free zones are available, the LED does not shine
c) The zone you want to teach the detector to can be selected with SELECT key 1
d) SET key 2 opens the zone
e) Open the tamper contact on FTS 96 E or wireless magnetic contact by removing the cover
(to do that, the battery must be fitted to the FTS 96 E or wireless magnetic contact)
f) The radio signal is emitted and the detector is taught to the zone; an acoustic acknowledgement follows
g) The next free zone is then indicated with the green LED
h) For teaching additional detectors, see Point 4 c
i) Exit the menu using ESC key 3
5. Deleting a taught detector (Submenu LED 02):
a) Press SELECT key 1 once: Main menu
b) Press SELECT key 1 once
c) Press SET key 2 once: Submenu LED 02 (delete detector) opens
flashes orange
d) You can select the detector you want to delete with SELECT key 1
e) Press SET key 2 (LED flashes more quickly) until the LED goes out
f) The next assigned zone then is indicated by the flashing orange LED
g) To delete additional detectors, see Point 5 d)
h) Exit the menu with ESC key 3 or automatically after deleting the last assigned zone
6. Radio signal strength indicator (Submenu LED 03):
a) Press SELECT key 1 once: Main menu
b) Press the SELECT key 1 twice:
c) Press SET key 2 once: Submenu LED 03 (Radio signal strength indicator) opens
assigned zone shines green
d) Use SELECT key 1 to select the detector for the last received radio signal level you want to display
e) Press SELECT key 1 once: The last received signal strength of the first assigned zone is displayed via the number
of shining LEDs starting with LED 16; the more LEDs shine, the higher the received radio signal strength.
To ensure permanently secure radio reception, at least three LEDs should be shining
f) The next zone can be tested with the SELECT key, etc.
g) Exit the menu using ESC key 3
7. Delete all / Factory reset (Submenu LED 16):
a) Press SELECT key 1 once: Main menu
b) Press SELECT key 1 three times:
c) Press SET key 2 once: Submenu LED 16 (factory reset) opens
d) Keep SET key 2 pressed (LEDs flash faster) until all LEDs 01 – 16 go out
e) The radio controlled display module automatically returns to the display mode
Notes:
The radio controlled display module automatically returns to the display mode if no activity has occurred
for a period of ca. 3 minutes (no keys were pressed and no detector was taught).
If no radio signal has been detected from the respective radio alarm for ca. 15 minutes,
a supervision error is indicated by the red LED 18 and the respective zone LED flashing green.
12
LED 01 is shining green
LED flashes green (ready for learning)
LED 01 is shining green
LED 02 shines green
LED 01 is shining green
LED 03 shines green
LED 01 is shining green
LED 16 shines green
The LED in the first free zone shines green
The LED in the first assigned zone
detector deleted
The LED in the first
LEDs 01 – 16 flash red